Denton, TX's Proven Basement Waterproofing & Crawl Space Repair Company

This homeowner noticed that their crawl space was causing moisture issues throughout their home. One of our System Designs Specialists, Ross, inspected the crawl space and found evidence of moisture issues. He presented a solution for encapsulating the crawl space to the homeowner, and the homeowner was pleased to accept the estimate and proceed with a full crawl space remediation from Olympic Restoration Systems.

This customer called stating that he believed his crawl space was leadning to multiple moisture issues throughout his home. He found mold on his ceiling and on his leather clothing, and he was running a dehumidifier contantly to no avail. We sent one of our System Designs Specialists, Tyler, to the property for a free estimate. After inspecting the crawl space, Tyler found further evidence of crawl space moisture issues. Tyler presented a soltution to encapsulate and condition the crawl space so that there would not be any more moisture issues. The homeowner accepted and proceeded with a crawl space remediation from Olympic Restoration Systems. 

The production team started by removing debris from the crawl space and regrading the soil. This keeps water from pooling in low points of the crawl space floor. They sloped the soil so that water would flow to the sump pump. Next, they placed a SmartSump to drain water away from the crawl space. They then placed drainage matting underneath a CleanSpace vapor barrier on the crawl space floor to isolate the home from the earth. The drainage matting allows water to flow to the sump pump. The vapor barrier protects the crawl space and home from any moisture collecting in the sump pump. They closed off any outside air, from vents or any other opening, to keep the outside air from entering the crawl space. Finally, they placed a SaniDry Sedona dehumidifier in the crawl space to dry any moisture from the air.

This customer called wanting a quote for blown in cellulose attic insulation in Denton, TX. We sent one of our System Designs Specialists, Tyler, to the home for a free estimate. Upon inspection, Tyler found that the attic had sparse existing attic insulation that did not cover all areas of the attic. The thin layer of existing insulation was not sufficient to keep the attic properly insulated. He proposed a solution to the homeowner, which included adding blown in TruSoft cellulose insulation to the existing attic insulation. The homeowner accepted the proposal, and our production team went and completed the attic insulation installation.

After hard rains began seeping into this home, these homeowners noticed mold growing. They contacted our team to help. We set up a containment area and removed all affected organic materials. We then removed the mold using an EPA registered anti-microbial, and HEPA vacuum, leaving these homeowners with a healthier home environment. 

These homeowners were trying to protect their home by running several large dehumidifiers but they seemed to be working around the clock. Deciding it was time to stop the humidity issue by encapsulating their crawl space, they contacted our team to help. We installed a CleanSpace encapsulation system along with a sump pump drainage system, helping these homeowners stop the humidity issue from the ground up.  

This house had mold in the bathroom, and the living room. The mold was everywhere in these two rooms due to a substantial water leak from the roof around the chimney. The roof was repaired first, before performing any mold remediation.

We removed all sheet rock in the rooms and sanded down the studs and all framing members. The affected area is then hand wiped with an anti-microbial solution. We used a HEPA vacuum before and after the affected rooms were cleaned. The home was then tested and certified as mold-free.