Fort Worth, TX's Basement & Crawl Space Repair

Concerned about the effect of mold in their crawl space, these homeowners contacted us for a free inspection. We found humid conditions and the beginnings of mold growth, so we installed a CleanSpace crawl space encapsulation system to seal out humidity from the open ground. We also applied Mold-X2 Cleaner and Botanical to remove mold, stains, and odor while preventing future growth.

The leaks in this basement prevented the homeowners from using the space for storage, so they called us to waterproof the area and open it back up for use. We applied SaniDry waterproof sealant to an exterior wall that had moisture seeping out. We also installed a WaterGuard baseboard waterproof system to the area that had the most water leakage. Finally, the SmartSump pump system we installed captures and removed all the water that was blocked by the WaterGuard, so there is now no sitting water.

This historic downtown building was undergoing restoration after facing erosion particularly in the stairwell. We were called in to carefully and effectively waterproof the stairs before they installed new brick.

After priming the surface, we applied Liquid Rubber Base to the seam between the stairs and the wall to fill in an cracks. We then sealed the stairs with Permalfex to prevent future water instrusion. 

This home had several separated crawl spaces that each contributed a to the high humidity in the home. When our team was called in to inspect, we also found water seepage that added to the moisture in these crawl spaces.

We installed a pump system, CleanSpace encapsulation system, and three separate dehumidifiers to control the moisture and humidity.

After purchasing their first pier and beam home, this couple became concerned about all the standing water in their crawl space. Our specialist came out to evaluate the situation. Humidity in the crawl space was 79 and there was noticeable wood rot. Encapsulation was the answer. 

Our team used drainage matting, a CleanSpace vapor barrier, dehumidifier, and sump pump to protect the home from moisture. A panel was placed inside the house so the homeowners could monitor the humidity levels in their crawl space. 

A musty smell had these homeowners wondering if there was mold in their crawl space. Our specialist discovered high humidity and mold growth on the subfloor. 

To solve this issue, we removed the mold with an EPA registered antimicrobial and used an EPA registered botanical to prevent further growth. A dehumidifier was installed to keep the humidity below 60 percent and discourage mold growth. 

Due to improper yard drainage, water had been damaging these homeowners wood floor. When they went to replace it, they noticed mold. They contacted our team to help. We began by setting up a containment area with negative air scrubbers. Then, we removed all affected materials. Using an EPA registered antimicrobial and HEPA vacuum, we remediated the mold. 

These homeowners had a water heater leak. Mold growth was visible behind the water heater and on the adjacent wall. Our team set up a containment area with negative air scrubbers. We then removed all the affected materials and used an EPA registered antimicrobial, along with a HEPA vacuum to remove the mold. 

Due to improper ventilation in the bathroom, these homeowners were experiencing mold growth. Our team came in to remove it. We installed air scrubbers outside of the contained areas and ran them until the successful post-remediation inspection was achieved. After all the mold was taken care of we disposed of all of the debris and wiped down and sanded the materials we were able to save. Once we completed our work, the homeowner was able to enjoy a healthy, mold-free home. 

This customer contacted Olympic Restoration Systems because they thought they had mold in various areas their home. Upon inspection, we were able to identify where the mold growth was and we have a solution for that.

We installed air scrubbers outside of the contained areas and ran them until the successful post-remediation inspection was achieved. After all the mold was taken care of we disposed of all of the debris and wiped down and sanded the materials we were able to save. Once we completed our work, the homeowner was able to enjoy a healthy, mold-free home.

This customer contacted Olympic Restoration Systems because they thought they had mold in various areas their home. Upon inspection, we were able to identify where the mold growth was and we have a solution for that.

We installed air scrubbers outside of the contained areas and ran them until the successful post-remediation inspection was achieved. After all the mold was taken care of we disposed of all of the debris and wiped down and sanded the materials we were able to save. Once we completed our work, the homeowner was able to enjoy a healthy, mold-free home.